A linear five-port smoking machine (Hawktech FP2000, Tri-City Machine Works, USA), described in more detail elsewhere [26] and [31], was used to generate the mainstream smoke from the custom-mentholated cigarettes according to the International Organization of Standards/Federal Trade Commission (ISO/FTC) protocol (35 mL puff volume, 2 second puff duration, and one puff every 60 seconds for each cigarette).

Briefly, four TPM samples were collected (one per cigarette) by sequentially smoking four randomly selected custom-mentholated cigarettes from the same batch for seven puffs per cigarette. selleck products Experiments were performed with the custom-mentholated cigarettes immediately following the completion of the 72-hour mentholation period. TPM was collected on a 44-mm quartz fiber filter pad for further analysis. The TPM mass was estimated from the difference in the weight of the filter pad before and after mainstream smoke collection using a microbalance. Individual TPM filters were extracted for analysis of menthol and nicotine based on procedures previously developed for similar chemicals and matrices [26], [31], [32] and [33]. The samples were extracted with 50%

dichloromethane in acetonitrile and subjected to additional cleanup, as necessary, using solid phase extraction. The extracts were analyzed by gas PIK3C2G chromatography/mass spectrometry (GC/MS) [32] and [34]. Before mentholation experiments could begin, it was necessary to develop and

demonstrate see more the validity of a method for the extraction and analysis of both menthol and nicotine from the tobacco rod and cigarette filter. We present these results first, then those of the custom mentholation technique. Instrument calibration response was linear over the selected concentration range, such that the concentrations of primary and secondary source calibration verification standards always back-calculated to be within 12% of expected values. Solvent blank results were typically below the lower limit of quantitation of 5 μg/mL (corresponding to less than approximately 0.17 mg/g) for both menthol and nicotine. Menthol was usually not measured above 5 μg/mL in matrix blanks, yet nicotine was consistently detected in the matrix blank at approximately 50 μg/mL, corresponding to a nicotine concentration of approximately 1.7 mg/g. This is consistent with the published nicotine level of reformulated Quest 3 cigarettes of 1.5 mg/cigarette, which is roughly equal to 2.5 mg/g [35], where the conversion takes into account the typical approximate mass of tobacco filler in Quest 3 cigarettes (600 mg).